Tag Archives: MAX31855

OctoPROBER REV2 Released

BjCqx71CMAAm7eU

Above is the REV 1 of the OctoPROBER. This revision fixed allot of the issues I had with programming the propeller and the propeller resetting when the USB plug was plugged in. To fix the USB resetting the propeller when being plugged in I disconnected the reset line off the FT230X (USB chip) from the reset signal on the propeller. This breaks being able to program the propeller as it needs to upload code directly after start up. To fix this problem the code has a menu option that will reset the propeller if it sees the USB reset line so the user can control if the USB resets the propeller or not.

To enable ease of first time programing or encase the firmware gets borked there is a switch that manually connects the FT230X reset signal to the propeller reset signal.

Layout

Rev 2 of the OctoPROBER I decided to do away with the MAX31855 chips. They are very expensive ($5 a piece) and not very accurate (+-2C). Instead I am using 2 MCP3424 18-bit ADCs to do the thermocouple readings. To perform cold junction readings I am using 8 AT30TSE752 board temperature sensors. This should provide +-0.5C accuracy and the ability to use any thermocouple type.